LawnMaster FD1501 Manual De Uso página 12

ASSEMBLY INSTRUCTIONS
WARNING
If any parts are damaged or missing, do not operate this product until the parts are replaced. Failure to
heed this warning could result in serious personal injury.
WARNING
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING
Do not attempt to modify this product or create accessories not recommended for use with this product.
Any such alteration or modification is misuse, and could result in a hazardous condition leading to
possible serious personal injury.
Assembling this YARD Chipper need the follows tools:
• 6mm Hex Key (included)
• wrench
• Phillips screwdriver
ATTACHING LEGS TO CHIPPER
The legs are attached to the bottom of the chipper.
• Place the legs (1) into the holes (4) on the housing.
• Push firmly into place.
• Using a screwdriver tighten the two supplied screws (3) to the small holes (2) in the housing and the legs.
• Slide the axle through the two holes found at the curves of legs.
• Slide a transport wheel over the axle, support ribs directed in.
• Place washer over axle, push straight end of the cotter pin hole in axle and press into hole until
it is secured.
• Repeat transport wheel installation on other side.
• Align and push hub cap into place on both sides.
NOTE: Do not over tighten the screws.
(See Figures 4 & 5)
12