Kärcher HD 10/15 F Manual De Usario página 6

Reinsert the fastener
Check the connection for correct fit and
tightness
Pull the hose clamp over the hose and
fasten them to the attachment plate.
Screw M6 and hexagonal nut.
Screw the holder into the front screw
dome. Screw M5x8. Make sure that no
cables are crushed.
Route the connecting hose by the elec-
trical box
Close and lock the machine cover.
Remove the marked screws.
6
English
Fasten the side pieces to the hose
drum. Observe the hexagon socket on
the shaft.
Insert the crank in the hose drum shaft
and lock it in.
Grease the seal on the connecting
hose.
Insert the connecting hose into the later-
al coupling and secure with fastener.
Screw the holder onto the handle
Tighten the screws on the holders, en-
sure sufficient clearance so that the
hose drum does not rub against the
holder.
Position the appliance upright
The completely installed hose drum
Attach the high pressure hose (op-
tion)
Grease the seal on the high pressure
hose
Insert the high pressure hose into the
coupling
Insert the fastener
Wind the high pressure hose in uniform
layers on the hose drum by rotating the
crank. Select the rotation direction in
such a way that the high pressure hose
does not get bent.
Connect the high pressure hose to the
hand-spray gun.