Connections For The 60174 Booster; The Display For The Booster - marklin 60174 Manual Del Usario

2

Connections for the 60174 Booster

All transformers and switched mode power packs connected to the layout must be un-
plugged from the household current before connecting the Booster to the layout. Each
Booster and each Central Station must be connected to its own switched mode power
pack / transformer. The layout itself must be separated into planned power consumpti-
on areas. The different power consumption areas must be separated from each other
electrically. This means that the contact for the center conductor must be isolated
in H0 track at the transition points between power consumption areas. Both of the
running rails at these points must remain connected to produce a "common ground".
Plug the Booster into the Central Station at the socket marked "60173" and connect
the Booster to the track with the wire included with it (the Booster) (if you don't use
the wire included with the Booster, then make sure that the wire is no longer than 2.0
meters / 78"!). Make sure when making the connections that the red wire (B) is con-
nected to the center conductor (B) (The assignments for the wires must be the same
as for the Central Station!).
If you want to operate additional 60174 Boosters with the Central Station, then you can
connect the 60125 Terminal to the Central Station and connect up to four Boosters to
each Terminal.
3

The Display for the Booster

Am Booster 60174 ist bei den Anschlussbuchsen eine rote Leuchtdiode (LED), die
verschiedene Zustände des Boosters anzeigt:
8
B
0
�������
0 B
B
0
0 B