Publicidad
Idiomas disponibles
Idiomas disponibles
®
Install SKS
Locks
following lock
instructions.
Maneuver the crossbars
into the towers on the vehicle roof.
CLOSE levers on all
towers.
If lever WILL NOT
CLOSE COMPLETELY,
make sure the base is
aligned to the tower.
BE SURE THE
DEPRESSIONS IN
THE BASES are facing
inboard on vehicle's
NOTE: Closing the levers
roof as in step 2.
secures towers to bases.
Yakima Products ("Yakima") will repair or replace merchandise which proves defective in materials and/or workmanship. The limited warranty is effective for one year from the date of purchase. The limited warranty is applicable
only if the Fit List and instructions are followed and the products are used properly. If a customer believes that a Yakima product is defective, the customer must return it to an authorized Yakima dealer with proof of purchase.
Yakima will then issue authorization to the dealer for the return of these products. If an article is found to be defective upon inspection by Yakima, Yakima will repair or replace the defective article at its discretion without charge.
The customer will pay freight to Yakima, and Yakima will pay any applicable return freight. Unauthorized returns will not be accepted. Normal wear and tear of Yakima products or damage resulting from misuse, accidents, or
alterations are not covered by this Limited Warranty. The purchaser acknowledges that Yakima has no control over the attachment of its products to vehicles or the attachment of items to the Yakima products. Accordingly, Yakima
cannot assume responsibility for any damage to any property arising out of the improper attachment or use of its products. In addition, this Limited Warranty applies only to Yakima products and not to other products used in
conjunction with Yakima products. This Limited Warranty is in lieu of all other warranties, expressed or implied, and does not cover consequential damages of any kind that may arise from the use or misuse of any Yakima product.
Rotate the small hole inside the
lock housing so that the point on
the core will align properly.
OK
WITH
LEVERS
OPEN,
slide towers
onto bases.
If crossbar will not slide in,
loosen tower hood screw.
WARNING:
Avoid over loosening the screw.
Dissassembly may occur!
TEST INSTALLATION
by pulling on each
tower and each bar.
Install end caps
on crossbars.
Some play between
tower and base is
Tighten
hood
screws after
crossbars are
centered.
Check the included
RailRider Fit Sheet
normal.
for your vehicle's limits.
DO NOT EXCEED
the maximum weight limit of
your factory tracks.
ALWAYS SECURE long loads
at the front and rear.
Part #1031606 RevA
Publicidad
