Specifications; Operating Instructions - OHAUS STLC1DG Manual De Instrucciones

s
PeCifiCaTions
Overall dimensions (L x W x H):
Top plate dimensions (L x W):
Electrical (50/60 Hz)
Model STLC1DG: 120 volts:
Model STLC2DG: 120 volts:
Fuses:
Speed range:
Model STLC1DG:
Model STLC2DG:
Speed stability:
Weight capacity:
Volume (H2O):
Model STLC1DG:
Model STLC2DG:
Timer:
Controls:
Ship weight:
5
28.5 x 26.75 x 5.25"
(72.4 x 68 x 13.3cm)
21.25 x 25" (54 x 63.5cm)
1 amp, 41 watts
1 amp, 82 watts
5mm x 20mm, 5 amp quick acting
100 to 1800rpm (increased in 10rpm
increments)
100 to 1650rpm (increased in 10rpm
increments)
±2%
425lbs (193kg)
100L
200L
digital, 1 second to 9,999 minutes
(increased in 1 second increments)
see page 4
63lbs (28.6kg)
o i
PeraTing nsTruCTions
The Large Capacity Stirrer has been designed for the speed and time functions to
work independently of one another. The speed can be re-set without re-setting the
timer and the timer can be stopped and started without interrupting the stirring function.
1. Getting ready:
a. Plug the power cord into a properly ground outlet. The standby indicator light
will illuminate, verifying power to the unit.
b. Press the standby button in order to move the unit from standby mode. The
standby indicator light will turn off and the speed/time displays will illuminate
and display the previously used settings.
2. Setting speed:
a. Press the up/down arrows below the speed display until you reach the desired
speed. When you release the arrow button, the unit will blink off and then on
indicating the new set speed has been accepted.
b. Press the on/off button to start the stirring function. The indicator light below
the speed display will illuminate to indicate the stirring function is in-use. While
accelerating, the indicator light will blink until set-point is reached and then will
remain lit until stirring has ceased. The microprocessor controlled ramping
feature slowly increases speed until the set-point is reached which helps to
avoid splashing and provides excellent low end control. The microprocessor
also regulates the stirring speed, sensing your requirements whether stirring
an aqueous, viscous, or semi-solid solution.
c. Speed adjustments can be made without interrupting stirring by using the up/
down arrows below the speed display. After the change has been made and
you release the arrow button, the unit will blink off and then on indicating the
new set speed has been accepted.
d. To stop the stirring function, press the on/off button below the speed display.
3. Setting time to zero (0:00) and continuous mode: Accumulated time.
a. Press and hold the on/off button below of the time display. After three (3)
seconds, the display will indicate the previous set time.