Publicidad
• Fixture can NOT be used with a dimmer switch.
• To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts,
cuts/abrasions, and other hazards read all warnings and instructions included with and on the the
fixture box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon this equipment, follow these
general precautions.
• Commercial installation, service and maintenance of luminaires should be performed by a qualified
licensed electrician.
• For Residental installation: If you are unsure about the installation or maintenance of the luminaires,
con-sult a qualified licensed electrician and check your local electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov.
• This fixture should not be used in areas with limited ventilation or high ambient temperatures.
• This fixture is intended to be connected to a properly installed and grounded UL listed junction box.
• These instructions do not purport to cover all details or variations in equipment nor to provide every
possible contingency to meet in connection with installation, operation, or maintenance. Should
further information be desired or should particular problems arise which are not covered sufficiently for
the purchaser's or owner's purpose, this matter should be referred to Acuity Brands Lighting, Inc.
!
WARNING: RISK OF ELECTRICALSHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical Code and any
applicable local code requrirements.
• All wiring connections should be capped with UL approved wire connectors.
!
CAUTION: RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton,installing, servicing or
performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
!
WARNING: RISK OF BURN
• Allow fixture to cool before handling. Do not touch enclosure or light source.
• Do not exceed maximum wattage marked on lumi-naire label.
• Follow all lamp manufacturer's warnings, recom-mendations and restrictions for: driver type, burning
position, mounting locations/methods, replacement, and recycling.
• Use only lamps that comply with ANSI standards.
!
CAUTION: RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• Minimum 90° C supply conductors.
IMPORTANT SAFETY
INSTRUCTIONS
Page 3
Publicidad
