geberit ECO 203 Manual De Operación página 30

Ocultar thumbs Ver también para ECO 203:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 79
EN
Fault
Red LED lights up.
The pressing tool remains
unchanged and no LED
lights up.
Red and green LEDs flash
alternately.
30
Cause
Pressing tool is
overloaded.
Non-permissible
pressing systems are
being used.
Mains voltage is too
low.
Pressing tool is
defective.
Network failure.
Maintenance interval
has been reached.
Action
▶ Release start button.
▶ Press and hold release button: roller
drive moves to its starting position.
▶ Repeat the pressing operation: press
the start button for at least 2 seconds.
▶ Release start button.
▶ Press and hold release button: roller
drive moves to its starting position.
▶ Only use permissible pressing
systems.
▶ Have the pressing tool inspected by
an authorised repair shop.
▶ Check the mains voltage.
▶ Fully unreel the cable drum of the
extension cable.
▶ Reduce extension.
▶ After a network failure, press and
hold release button: roller drive
moves to its starting position.
▶ Have the pressing tool inspected by
an authorised repair shop.
▶ Release start button.
▶ Press and hold release button: roller
drive moves to its starting position.
▶ Check the pressfitting for tightness
and repeat the pressing operation if
necessary.
▶ Have the pressing tool inspected by
an authorised repair shop.
9007201149220747-1 © 02-2018
968.385.00.0 (00)

Publicidad

Tabla de contenido
loading

Tabla de contenido