Publicidad
Parts Included
A. Basket Hanging Rack
B. Post
C. Top mount kit
D. Shaft collars (2)
E. Waste bins (3)
F. Color coded labels (6)
G. Mounting Screw Package
A.
B.
E.
Tools Required
• Phillips screwdriver
• T ape Measure
• Pencil
• Drill with 3/32" bit for pilot holes
(optional)
©2020 Knape & Vogt Manufacturing Company.
All rights reserved.
Product Assemblies
RN282EFS-REV C 10/20
RRC28K
KNAPE & VOGT MANUFACTURING COMPANY
P. O. Box 191, Muncie, IN 47308
0.899.6535 • 765.288.8730 • Fax 765.288.0851 • www.kv.com
ROTARY RECYCLING CENTER
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
Step 1 Place both of the shaft collars on
post. Bottom collar should have
slotted side up. Place basket hanging
rack on post. Locate near top of post
and tighten set screw in collar. Insert
the top mount support into top of post.
Step 2 Locate the unit as assembled inside
your cabinet. Position the unit so the
open side of the basket hanging rack
C.
will straddle the door as shown.
Check for interference by closing
cabinet door. Be sure to allow for the
D.
basket rim which will hang over each
side of rack. Mark the four screw
holes on the cabinet floor. Fasten in
place using the screws provided.
Step 3 Lift the top mount
support to the top of the
cabinet and secure it in
F.
place using the screws
and star washers
provided. Place the
three wastebaskets on
the basket hanging rack.
Color-coded labels may
be applied to bins.
Installation is now
complete.
Top View
©2020 Knape & Vogt Manufacturing Company.
©2020 Knape & Vogt Manufacturing Company.
RN-210EFS-REV B 10/20
RN-210EFS-REV B 10/20
step 1
step 2
step 3
step 4
All rights reserved.
All rights reserved.
Publicidad
