Crosley XPS15BTH Manual Del Propietário página 15

Installation Instructions
REVERSING THE DOOR SWING (Cont.)
WARNING
Follow all steps when reversing
the door swing . Failure to follow these instructions,
leaving off parts, or overtightening screws, can lead
to the door falling off and result in injury and property
damage .
REMOVE THE FRESH FOOD
3
DOOR
3 .1 Tape the door shut
with masking tape .
3 .2 Unscrew the center
hinge pin and remove
it from its socket . Be
careful not to lose
the center hinge and
washer .
3 .3 Remove the tape and tilt the door away from
the cabinet . Lift the door from the pin in the
bottom hinge . (If the plastic washer sticks to
the door bottom, put it back on the hinge .)
3 .4 Set the door outside-up on a non-scratching
surface .
49-1000109
REVERSING THE HARDWARE
4
4 .1 Interchange the hinge and screws at top
4 .2 Remove the three screws holding the center
4 .3 Transfer the three screws from the opposite
Center
Hinge Pin
Washer
4 .4 Reattach the center hinge with all three
4 .5 Remove the screws holding the bottom hinge
Plastic
Washer
Hinge
Pin
right with screws at top left of cabinet . Do not
tighten screws on hinge side .
NOTE: Some hinges have 4 holes . Which
holes you use for installing depends on which
side you install the hinge .
The outer edge of the hinge should be
parallel to the edge of the case for correct
installation .
hinge to the cabinet .
side of the cabinet to the screw holes vacated
by the center hinge removal .
screws on the left side of the cabinet .
NOTE: The center hinge must be turned over
as shown when mounted on the left side .
to the cabinet . Move the bottom hinge from
the right to left side of the cabinet . Switch the
hinge pin to the opposite side of the hinge
and reinsert the screws .
Plastic
Washer
Switch the
hinge pin to the
opposite side of
the bracket .
Hinge
Bracket
Hinge
Pin
Hinge
Bracket
15