Uline H-7826 Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Power Indicator Light
1. Power Switch
15. Wireless Channel
Selector
14. Wireless ON/OFF Switch
13. DC In Jack
(for optional AC Adapter)
CHANNEL
5
4
6
3
7
2
8
1
9
16
10
15
11
14 13 12
UHF WIRELESS RECEIVER
1.
Power Switch
2. Power Indicator Light – Turns red when power is
turned on.
3. Mic Volume Control – Knob controls output loudness
to all three microphone inputs and siren.
4. Dynamic Mic Jack – Used for a handheld
microphone with 1/4" connector.
5. Auxiliary Volume Control – Knob controls auxiliary
volume separately from microphone volume.
6. Tone Control – This knob controls the tone of auxiliary
input. Turn counter-clockwise for more bass or
clockwise for more treble.
7.
Left and Right Speaker Jacks – Two separately
amplified speaker jacks allow you to use one or two
speakers for additional sound power or true stereo
output.
TO OPERATE
Plug gooseneck microphone into the condenser jack. Check to see that speakers are plugged in. Turn amplifier on.
Turn microphone on and talk into microphone. Rotate mic volume control knob to obtain desired loudness level. For
wireless microphone use, slide the on/off switch to on. Switch is located just below main power switch of amplifier.
Make sure both transmitter and receiver are on same frequency channel. Turn on wireless microphone. RF LED on
side of amplifier will light, meaning that it is receiving signal. If RF LED does not light, check channel numbers.
PAGE 5 OF 21
AMPLIFIER CONTROLS
3. Mic Volume Control
MAIN
WIRELESS
WIRELESS
ON
OFF
DC IN
POWER
11. Condenser Mic
12. Aux Out
Jack – 3.5 mm
Wireless 16 Channel Selector (left side of case) – Rotate knob
to select wireless channel on the built-in receiver. RF LED will
RF
light up when receiving signal from transmitter.
ON
NOTE: C
4. Dynamic Mic
5. Auxiliary
Jack – 1/4"
Volume
LINE IN L+R
SEPARATE
1
ON
COMBINED
DYNAMIC
VOLUME
VOLUME
2
3
AUX OUT
CONDENSER
WIRELESS
LINE IN
MIC
AUX
10. Wireless Mic
Jack – 3.5 mm
hannel selected must match.
8. Line Out Jack – Can be used with a tape recorder
The line out jack outputs all sound from microphone
and auxiliary inputs.
9. Auxiliary Line In Jack – Can be used with tape,
CD or MP3 player.
10. Wireless Mic Jack – For optional wireless receiver.
11. Condenser Mic Jack – Plug in gooseneck
microphone here.
12. Aux Out – For optional 12-15 volt accessory.
13. DC In Jack – Used for the 12V battery cable or
12V power plug.
14. Wireless ON/OFF Switch – Switches power on to
built-in 16 channel wireless receiver.
15. Wireless 16 Channel Selector – Channel selected
here must match with the channel selected on the
body pack/handheld microphone transmitter.
6. Tone Control
7. Left and Right
Speaker Jacks – 1/4"
8. Line Out
TONE
L–SPEAKER–R
LINE OUT
OUTPUT
9. Auxiliary Line In
Jack – 3.5 mm
3.5 mm
0621 IH-7826

Publicidad

Tabla de contenido
loading

Tabla de contenido