Orp Probe Menu - Davey DPLGEU Instalación E Instrucciones De Funcionamiento

• Press menu/setting select, the display then shows the pH set point (refer Figure 6.18);
The factory default pH set point is 7.4, however you may wish to change this once the Davey Lifeguard is
installed. It should be noted that Chlorine's effectivity is greatly influenced if pH levels are too high, or too
low. Davey recommends following the pool levels shown in section 10.
Figure 6.18
Adjustments to pH set point can be made as follows:
• Use the menu up/down buttons to scroll to your desired set point;
• Once correct, then press

6.7 ORP PROBE MENU

• The next screen shown asks if the ORP probe is currently connected and to be used (refer Figure 6.19);
Figure 6.19
• Use the menu up/down buttons to toggle between yes and no. Once correct, then
press menu/setting select;
• If you've chosen not to use (or wish to ignore for now) the ORP probe, skip to step 6.8 of this manual;
• If you've chosen to use the ORP probe, the next screen will instruct you to put the ORP probe into the
ORP solution (ref Figure 6.20);
Figure 6.20
ph set point:
-> 7.4
menu/setting select.
is the orp probe
connected?
->yes
ORP calibration:
put orp probe
into solution
->OK
24