Operation And Maintenance - Easy Home S570 Manual Del Usuaria

Robotic Vacuum
Spot Cleaning
• Press the Spot Cleaning Button to clean in a spiral pattern.
• It will stop automatically in about 5 minutes.
• The vacuum will stop cleaning if you press Spot Button during a cycle.
• Unit will beep if vacuum gets stuck on an obstacle that it cannot release itself from.
If unit gets stuck on any obstacles, pick the unit up and reposition it, then press
desired cleaning button.
SPIRAL PATTERN
Turbo Cleaning
• Press the Turbo Button and the vacuum's speed will change from normal to fast.
• Vacuum will run at a faster speed for approximately 60-90 minutes.
• Unit will shut off after a full cleaning cycle.
• Unit will beep if vacuum gets stuck on an obstacle that it cannot release itself from.
If unit gets stuck on any obstacles, pick the unit up and reposition it, then press de-
sired cleaning button.
ZIGZAG
6
service@801service.net

Operation and Maintenance

Robotic Vacuum
Charging Vacuum
Only use the supplied charging adaptor to
charge the vacuum.
Plug the adaptor into an electrical outlet. Plug
other end into vacuum. (See Fig. 1) Full charge
will take 3-4 hours. The 3 LEDs on top will blink
until vacuum is fully charged. The 3 LEDs go
solid when the vacuum is fully charged.
WARNING
Before cleaning the vacuum, make sure power button is in OFF position on bottom of
vacuum.
Cleaning The Dustbin
Remove the dustbin by pressing the release button on top. Shake dustbin over garbage
can and remove all dust and debris. (See Fig. 2 )
AFTER SALES SUPPORT
AFTER SALES SUPPORT
1 866 558 8096
Figure 2
Figure 2
1 866 558 8096
Operation and Maintenance
High Voltage! Electrical
Figure 1
Figure 1
Figure 3 Figure 4
service@801service.net
3 LED Lights
Figure 7
7