Spraying Technique; Cleaning A Clogged Tip - Titan HYDRA X 4540 Instrucciones De Uso

SPRAYING TECHNIQUE

5
SPRAYING TECHNIQUE
Injection hazard. Do not spray without the tip
guard in place. NEVER trigger the gun unless the
tip is completely turned to either the spray or the
unclog position. ALWAYS engage the gun trigger
lock before removing, replacing or cleaning tip.
A) The key to a good paint job is an even coating over the
entire surface. Keep your arm moving at a constant speed
and keep the spray gun at a constant distance from the
surface. The best spraying distance is 10-12 inches (25 to
30 cm) between the spray tip and the surface.
A
B) Keep the spray gun at right angles to the surface. This
means moving your entire arm back and forth rather than
just flexing your wrist.
Keep the spray gun perpendicular to the surface,
otherwise one end of the pattern will be thicker than the
other.
B
C) Trigger gun after starting the stroke. Release the trigger
before ending the stroke. The spray gun should be
moving when the trigger is pulled and released. Overlap
each stroke by about 30%. This will ensure an even
coating.
18
25 - 30 cm
C
25 - 30 cm
If very sharp edges result or if there are streaks in
i
the spray jet – increase the operating pressure or
dilute the coating material.
5.1

CLEANING A CLOGGED TIP

If the spray pattern becomes distorted or stops
i
completely while pulling the trigger, perform the
steps below.
1. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual, section 4.7.
2. Clear the spray tip per the instructions in the spray gun
operation manual.
The flow from the spray tip is at very high pressure.
Contact with any body part may be dangerous.
Do not place finger on gun outlet. Do not point
the gun at any person. Never operate the spray
gun without the proper tip guard.
HYDRA X
25 - 30 cm