Complete The Installation - Kohler K-657 Guia De Instalacion

Grommet
Low Voltage
Access Cover
Indicator Light
High Voltage
Access Cover
4. Connect the Interface(s)
CAUTION: Risk of electric shock or product damage. Make sure the power cord for the media
module is unplugged before removing the access covers.
Remove the low voltage access cover on the media module.
Remove the grommets in the locations where the interface cable(s) will be installed. Refer to the
"Connection Key."
Gently press each connection until it snaps together.
Slide the cable grommet into the slot with the male end up. Verify the grommet is properly seated.

5. Complete the Installation

If not already installed, install any additional components at this time according to the installation
instructions packed with the products. For connecting to the media module, refer to the "Connect
the Components" section in the Media Module Installation Guide.
Reinstall the media module access covers. Do not over tighten.
6. Installation Checkout
Plug the media module power supply into the outlet. Verify that the indicator light on the media
module turns on and pulses.
Turn on the water supply to the valve.
Check all connections for leaks and make any adjustments as needed.
1069764-2-A
Male end
Slide grommet into slot with
male end up.
1/2" (1.3 cm) D.
Knockout
Make sure power cord is unplugged
before opening access covers.
10
Install grommets
flush with media
box.
Lighting Connection
Line
Neutral
Ground
Use copper
wire only.
Kohler Co.