Maintenance, Cleaning, And Storage - Guardian 3 Harness Serie Manual De Instrucciones

4. Adjust chest strap height to
lower chest level, approximately
6" from top of shoulders. Connect
chest strap. Ensure there is no
twisting of webbing.
Some steps of donning a harness may require assistance from another person. Upon completely
donning a harness, Guardian Fall Protection recommends that another person, with knowledge of the
safe and correct use of the harness, inspect to ensure the harness is being worn correctly.

Maintenance, Cleaning, and Storage

If a Series 3 Harness fails inspection in any way, immediately remove it from service, and contact Guardian to
inquire about its return or repair.
Cleaning after use is important for maintaining the safety and longevity of Series 3 Harness. Remove all dirt,
corrosives, and contaminants from Series 3 Harness before and after each use. If a Series 3 Harness cannot be
cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean Series 3 Harness
with corrosive substances.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture, chemicals,
or other degrading elements.
5. Adjust chest, leg, and
shoulder straps so they fit
snugly, but still allow for a
full range of movement.
! WARNING
Any twisting of webbing, or
straps that are fitted too loose
or too tight, can significantly
increase the risk of serious
injury or death in the
event of a fall.
6