Installation Instructions - Springer BC-127 Manual Del Usuario E Instalación

All manuals and user guides at all-guides.com
- Its better to install your appliance on the walls facing east or south,
where solar incidence is weaker.
- avoid using the cooling function of your appliance with indoors tem-
peratures lower than 20
heat exchanger.
- To avoid freezing of the external heat exchanger, do not use the heating
function with outdoors temperatures lower than 4
- WHENEVER you want to change from the cooling function to the warm-
ing function, or conversely, turn off the equipment and wait at least 2
minutes before turning it on again.
- If electrical energy is interrupted, immediately turn your unit off and
turn it on again just after 1 minute of the energy re-establishment. This
procedure will avoid damage to the compressor due to tension varia-
tions.
- Do not use the temperature control (thermostat knob) as a switch to
turn on-off the equipment. The thermostat is the principal safety device
of its electrical circuit.
N

INSTALLATION INSTRUCTIONS

INSTALLATION ON WALLS
The opening in the wall must allow the perfect fit of a framework to fix the appliance,
as well as to give a decorative finishing. Remember that the wooden beams of the framework
must be of at least of 2.5 cm thick.
You must have in mind that the wall you choose to install the unit on must be free of
pillars, girders, pipelines and electrical ducts. According to the following table and the previous
figure, chose the internal sizes of the framework:
A
Dimensions 60,5 cm
O C, so ice may not be formed on the internal
B C (máx.)
38,5 cm 17,0 cm
4
O
C.