Taurus ALPATEC AC205RVKT Manual Del Usuario página 20

e. Fan indicator mode
f. Heater indicator mode
g. Timer indicator
h. Up / down indicator
i. High speed indicator
j. Low speed indicator
k. Sleep indicator
l. Swing indicator
INSTALLATION
- Be sure to remove any packing material from
the inside of the appliance.
- Respect the legal provisions regarding safety
distances with other elements such as pipes,
electric conductors, etc.
- Make sure the appliance is level with the floor
- Do not cover or obstruct any openings in the
appliance.
- The plug must be easily accessible in order to
disconnect it in case of emergency.
MOUNTING THE EXHAUST PIPE:
- Stretch the tube, and screw its end to the air
outlet connector.
- The length of the air outlet pipe conforms to
the technical characteristics of the appliance.
Do not use air outlet tubes of different sizes or
materials, as they may cause faults.
INSTRUCTIONS FOR USE
USE:
- Unroll the cable completely before plugging it
in.
- Connect the appliance to the mains.
- Press the ON/OFF button, the unit will enter in
cooling mode with low fan speed.
- Press the mode button to select cooling dehu-
midifying, fan and heating mode.
FAN SPEED
- Under the cooling and the fan mode, the speed
goes as follow:
- Lower Fan→ High Fan.
- Under the dehumidifying mode, fan is working
in low speed.
TIMER FUNCTION:
- The appliance´s operating time can be con-
trolled from 1~24h.
- Press that button.
- You can set time through up and down buttons.
- Auto-shut off timer is only available when the
unit is on.
- Up and down button can set temperature and
timer.
- Under the cooling and heating mode, the set-
ting temperature ranges from 16º~31ºC.
SWING
- Press this button to control the movement of
the louver.
COOLING MODE:
- Press mode to select cooling mode, cooling
mode indicator turns on.
- Press Up or Down to adjust temperature from
16ºC to 31ºC.
- Press speed to select high or low fan speed.
HEATING MODE:
- Press mode to select heating mode, heating
mode indicator turns on.
- Press Up or Down to adjust temperature from
16ºC to 31ºC.
- Press speed to select high or low fan speed.
FAN MODE:
- Press mode to select fan mode fan indicator
turns on.
- Press speed to select high speed or low speed.
- Temperature and sleeping function cannot be
setup.
DEHUMIDIFYING MODE:
- Press "MODE" to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Under dehumidifying mode, sleeping function
cannot be setup, and fan speed is low.
SLEEPING MODE:
- Press key "SLEEP" enter into sleeping mode,
default value of fan speed is low.
- When sleeping mode turns on , under cooling
mode, the first one hour later, setting tempera-
ture will go up 1ºC, the second one hour later,
setting temperature will go up another 1ºC, and
then keep the same .
- Sleeping mode is invalid under dehumidify-
ing and fan mode. Under water full, machine
standby and mode conversion, sleeping mode
will be cancelled
COMPRESSOR PROTECTION:
- Three minutes later after power on / restart,
compressor starts to run.