sunjoe iON8PS2-LT Manual Del Operador página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Remove the cutting bar and chain from the mounting
surface (Fig. 3).
Fig. 3
Chain
4. Remove the old chain from the bar.
5. Lay out the new saw chain in a loop and straighten any
kinks. THE SHARP SIDE OF THE TEETH MUST FACE
AWAY FROM YOU IN THE DIRECTION OF THE CHAIN
ROTATION INDICATED ON THE GUIDE BAR
the teeth face backwards, turn the loop over (Fig. 4).
Fig. 4
Sharp cutting edge
Chain drive link
6. Starting at the tip, mount the chain drive links into the
bar groove, leaving a loop at the back of the bar. The
chain will loosely fit until it is placed on the sprocket.
(Figs. 5 & 6)
NOTE: Make certain of the direction of the chain
If the chain is mounted backwards, the saw will vibrate
abnormally and will not cut.
Fig. 5
Cutting bar
Fig. 6
. If
Loop
7. Hold the chain in position on the bar and place the loop
around the sprocket. Fit the bar flush against the mounting
surface so that the bar studs are in the long slot of the bar
Chain rotation
and the adjusting pin is in the chain tension pin hole
(Fig. 7).
Fig. 7
.
Chain tension pin hole
(with adjusting pin)
10
R
Sprocket
Bar studs

Publicidad

Tabla de contenido
loading

Tabla de contenido