MBO Merkura 1050 Instrucciones Para El Servicio página 38

Merkura 1050 GB neu
14
USING THE PULSE COMPUTER
Z
O
N
E
C
Z
O
N
E
C
www.MBOservice.net
27.03.2003
All manuals and user guides at all-guides.com
1. Setting the alarm zone
In pulse mode, keep pressing key "B" until the
letters ZN are displayed in the centre line of the
display. Press and hold down key "C" until the
symbols for the upper and lower training limits
start to flash.
Use key "B" to select one of the following
zones:
B
Alarm only when you exceed the training
zone – 2 beeps per second
Alarm only when you fall below the
training zone – 1 beep per second
Alarm when the pulse is outside the
training zone
After setting the alarm zone, press key "C" to
switch to training zone selection mode.
2. Selecting the training zone
After switching to training zone selection mode,
the currently selected training zone (1, 2, 3 or U)
in square brackets starts to flash. The relevant
upper and lower limits also flash in the bottom
line. You can switch between the 4 training
zones by pressing key "B". Confirm your selec-
tion with key "C". This completes the alarm zone
B
selection process.
Note:
You must set the alarm zone before selecting the
training zone.
8:31 Uhr Seite 14