To Do A Check Of The Oil Level; Troubleshooting - Husqvarna CL400 Manual De Usuario

4. Loosen the screws and remove the blade. Refer to
the figure (C) to (E).
C
D
5. Loosen the screw and then remove the head. Refer
to the figure (F) to (G).
F
If you cannot find a solution to your problems in this
manual, speak to your Husqvarna service agent.
12
E
G

Troubleshooting

6. Blow the entire product with compressed air and
remove completely any residue of dirt, grass.
Remove dirty grease with a suitable solvent, if
necessary. Refer to the figure (H).
H
7. Clean all components with a suitable solvent and
lubricate every component. Refer to the figure (I).
I
8. Apply water-repellent grease on the shaft of the
cutter. Refer to the figure (I).

To do a check of the oil level

CAUTION: A too low oil level can do
damage to the engine. Do a check of the oil
level before you start the product.
1. Put the product on level ground.
2. Remove the oil tank cap with the attached dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank to give a correct
picture of the oil level.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again.
1394 - 002 - 27.11.2019