Maintenance And Cleaning; Troubleshooting - Global 246726 Manual Del Usario

User's Manual

MAINTENANCE AND CLEANING

No user maintenance on this heater should be undertaken except
regular cleaning as described below. All other servicing or
maintenance should be performed by qualified service personnel.
Before any cleaning, make sure that:
1.Power supply is disconnected at the source. Switch off the
circuit breaker.
2.Wait 60 minutes to ensure the heating element has cooled down.
Your heater is now ready for cleaning.

TROUBLESHOOTING

If your heater fails to operate, please follow these procedures:
This heater is intended to be a ceiling/wall-mounted heater. It has a thermal cut-off protection. If the thermal cut-off protection trips,
switch off the power. Switch off the circuit breaker. The unit should reset automatically after 10 minutes. If the thermal cut-off protection
trips again, consult a certified/licensed electrician to determine the reason for overheating
Problem
Unit is not heating.
The heater is producing a burning smell.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO COULD
CAUSE DAMAGE TO THE HEATER OR PERSONAL INJURY.
Horizontal Downflow Unit Heater
With Remote Control
Regular Cleaning:
1.Do not spray chemicals or other cleaning liquids on the heater.
2.Interior dust can often be removed by using a vacuum cleaner
with a crevice tool attachment.
3.To clean enclosure, use a clean, soft, and lightly damp cloth to
gently wipe off the dirt from the surface of the unit. Make sure
the heating element and the switches do not get wet. Allow the
unit to dry completely before use.
DO NOT ALLOW WATER TO RUN INTO THE INTERIOR
OF THE HEATER AS THIS COULD CREATE A FIRE OR
ELECTRIC SHOCK HAZARD, DAMAGING THE UNIT.
Probable Cause
Overheat protection has temporarily
deactivated the heater.
Room temperature is higher than the set
temperature.
Breaker/Fuse has been tripped.
Check & ensure there are no
combustible materials within 0.9 meters
(3 feet) surrounding the heater.
A drop of oil fell on the heating coil
during the manufacturing process. It will
quickly evaporate and should not occur
again.
Ensure a minimum clearance of 1ft (12
inches) from both sides, and 4.5 inches
from the back.
7
.
Solution
Turn the heater OFF. Switch off the
circuit breaker. Wait 10-30 minutes
before turning on the heater.
Increase thermostat setting to a higher
temperature.
Check your electrical box to confirm the
breaker has not been blown. This may
occur if the receptacle is shared with
other high consumption appliances.
Remove any combustible items from the
vicinity of the heater.
Ensure room in which heater is situated
is well ventilated.
Reposition the heater so there is enough
space between the heater and any
adjacent surface/wall.