To Fix The Fluorinated Greenhouse Gases Label; Connecting The Electrical Wiring; About Electrical Compliance; To Connect The Electrical Wiring On The Outdoor Unit - Daikin Altherma ERLQ004CAV3 Manual De Instalación

3.5.3 To fix the fluorinated greenhouse gases
label
1 Fill in the label as follows:
a From the multilingual fluorinated greenhouse gases
label peal off the applicable language and stick it on
top of a.
b Factory refrigerant charge: see unit name plate
c Additional refrigerant amount charged
d Total refrigerant charge
2 Fix the label on the inside of the outdoor unit near the gas and
liquid stop valves.
3.6

Connecting the electrical wiring

DANGER: RISK OF ELECTROCUTION
WARNING
Always use multicore cable for power supply cables.
3.6.1

About electrical compliance

Only for ERLQ006CAV3+ERLQ008CAV3
Equipment complying with
International Technical Standard setting the limits for harmonic
currents produced by equipment connected to public low-voltage
systems with input current >16 A and ≤75 A per phase.).
3.6.2 To connect the electrical wiring on the
outdoor unit
1 Remove the 2 switch box cover screws.
2 Remove the switch box cover.
2x
3 Open the wire clamp.
ERLQ004~008CAV3
Daikin Altherma – Low Temperature Split outdoor unit
4PW73435-1A – 2012.11
a
b
c
d
EN/IEC 61000‑3‑12 (European/
1
1

4 Starting up the outdoor unit

4 Connect the interconnection cable and power supply as follows:
3x
5 Install the switch box cover.
3.7

Finishing the outdoor unit installation

3.7.1

To finish the outdoor unit installation

1 Insulate and fix the refrigerant piping and interconnection cable
as follows:
c
a
b
f
a Gas pipe
b Gas pipe insulation
c Interconnection cable
d Liquid pipe
e Liquid pipe insulation
f Finishing tape
2 Install the service cover.
4 Starting up the outdoor unit
See the indoor unit installation manual for configuration and
commissioning of the system.
1 2 3
d
e
Installation manual
7