Philips Performer FC9177/01 Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
replacing/emptying the dustbag
Always unplug the appliance before you replace the disposable dustbag or empty the reusable
dustbag.
replacing the disposable dustbag
-
Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.
even when the nozzle is not placed on the floor (Fig. 21).
1
Pull the cover upwards to open it (Fig. 22).

Lift the dustbag holder out of the appliance (Fig. 23).
Make sure you hold the dustbag upright when you lift it out of the appliance.

Pull at the cardboard tag to remove the full dustbag from the holder (Fig. 24).
The dustbag is sealed automatically.
,

Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder as
far as possible. (Fig. 25)
5
Put the dustbag holder back into the vacuum cleaner.
Note: If you have not inserted a dustbag, you cannot close the cover.
Emptying the reusable dustbag (specific countries only)
In some countries, this vacuum cleaner also comes with a reusable dustbag that can be used and
emptied repeatedly. You can use the reusable dustbag instead of disposable dustbags.
1
Remove the reusable dustbag from the appliance and the holder as described in section
'Replacing the disposable dustbag' above.

Slide the clip off the dustbag sideways.

Shake out the contents into a dustbin.

To close the dustbag, slide the clip back onto the bottom edge of the dustbag.
5
Reinsert the reusable dustbag into the holder and the appliance as described in
section 'Replacing the disposable dustbag' above.
Cleaning/replacing filters
Always unplug the appliance before you clean or replace the filters
Note: Only wipe the body of the appliance with a moist cloth.
Permanent motor protection filter
Clean the permanent motor protection filter every time you replace or empty the dustbag.
1
Remove the dustbag holder with the dustbag (Fig. 23).

Press the filter holder release tab (1) and take the filter holder out of the appliance (2). Take
the motor protection filter out of the filter holder. (Fig. 26)

Shake the filter over a dustbin to clean it.

Put the clean filter back into the filter holder. Fit the two lugs of the filter holder behind the
ridge at the bottom to ensure that it fits properly at the top (1). Then press home the filter
holder ('click') (2) (Fig. 27).
5
Place the dustbag holder with the dustbag back into the appliance.
English
9

Publicidad

Tabla de contenido
loading

Tabla de contenido