Publicidad
Idiomas disponibles
Idiomas disponibles
Caution:
Troubleshooting
All servicing of this
• If the pump fails to operate, check the following:
fountain must be
Check the circuit breaker, or try a different outlet to make
performed by
sure the pump is getting electrical power. NOTE: Always
authorized HoMedics
disconnect from electrical outlet before handling the pump.
service
Check the pump discharge and tubing for kinks and
personnel only.
obstructions. Algae build up can be flushed out with a gar-
den hose.
Remove the pump inlet to access the impeller area. Turn
the rotor to ensure it is not broken or jammed.
Monthly maintenance will add to your pump's life.
NOTE: Ensure that the electrical cord loops below the
electrical outlet to form a 'Drip Loop'. This will prevent
water from running down the cord into the electrical outlet.
• If the pump gurgles, spews, or "burps":
Check the water level to make sure the pump has enough
water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the
rate of evaporation; refill with water as needed.
• If water is splashing outside the fountain:
Attention:
If splash continues, adjust the flow control valve to a lower
In order to get best
setting.
results, please
operate pump
completely
submerged.
Keep the water
level above the
minimum water level
ALL THE TIME.
10
+
Figure 5
PVC Tubing
Inserts Here
Impeller
Pump Inlet
Front Plate
Flow
Control
Lever
Figure 6
Minimum Water Level
1 1
Back Plate
Housing
Suction Feet
Flow Control
Valve
(+) faster water
output
(-) slower water
output
Publicidad
