Product Description; Control Panel - IKEA SVAVANDE Manual De Instrucciones

ENGLISH

Product description

Control panel

Turns the motor on/off at speed one.
Speed
Turns the motor on at speed two / Activate charcoal filter
alarm.
Press and hold the button for approximately 2 seconds, with
all the loads turned off (Motor+Lights), to turn the Activated
Speed
Charcoal Filter alarm on. LED (A) flashes twice to confirm
To turn the alarm off, press the button again and hold for
at least 2 seconds.The relevant LED flashes once (A). Only for
recirculation mode.
Turns the Motor on at speed three / Reset alarm grease
filter saturation.
Press and hold the button for approximately 2 sec-
Speed
onds, with all the loads turned off (Motor+Lights), to
reset the grease filter saturation alarm. LED (A) flashes
three times.
Turns the motor on at Booster speed.
This speed is timed to run for 6 minutes. At the end of this
time, the system returns automatically to the speed that was
set before. If it is activated with the motor turned off, it will
Speed
switch to OFF at the end of the time. To deactivate it, press
button D or press button A.
Press briefly: Turns the lighting system on and off at
maximum intensity.
Light
Press and hold to change the lighting intensity up or down.
Upper chimney
Lower chimney
Hood body
LED Lighting
Grease filter
Control panel
Filters Alarm.
When the filter alarm is activated, the following messages
will appear over time:
Grease filter alarm must be cleaned: "A" key flashes once
per second.
Anti-odour filter alarm must be cleaned: "A" key flashes
twice per second.
Once the filters have been regenerated reset the alarm
signal.
5