Indicator Leds; Button Functions - Urmet iPercom miro 1160 Manual Del Usuario

1.1.

INDICATOR LEDS

The functions of the components listed in the paragraph above are shown in detail below.
6.
Multicolour indicator LED
Slowly blinking yellow: programming state on
Fast green blinking: confi rm pressing of the buttons
Slow red blinking: ringer mute
Slow green blinking: automatic door opener active
9. Green LED under the
On steady: call in progress
On blinking: conversation ongoing
11. Green LED under the
on blinking (max. 3 seconds): door opener confi rmation after pressing button
1.2.

BUTTON FUNCTIONS

State
STAND-BY
Button
Open
pedestrian
door
(3)
---
Special
function
(2)
Garage
door opener
or special
function
(2)
To enter and exit programming state, hold button
(1)
beeps will be heard and the yellow LED will blink slowly to indicate that programming mode is selected.
Programming mode will shut down in all cases after the 10 minute timeout (two long beeps will be
heard).
If confi gured beforehand.
(2)
According to how the door opener is programmed: free or secret.
(3)
8
button
button
WAITING
FOR DURING
PICK-UP AUDIO
(RECEIVING OPERATION
CALL)
Open Open
pedestrian pedestrian
door door
Audio End of current
activation conversation
Special Special
function function
(2)
Garage Garage
door opener door opener
or special or special
function function
(2)
FUNCTIONS
or
IN STAND-BY
AND ONLY
AFTER PRESSING
BUTTON
Open pedestrian
door
---
Call to switchboard
or intercom
(2) (2)
Call to switchboard
or intercom
(2)
(2)
pressed for longer than 5 seconds. Three fast
STATE OF
PROGRAMMING
(ONLY WITH DOOR PHONE
IN STAND-BY)
Connect / disconnect the automatic door
opening system
Call volume adjustment for door and fl oor
level calls (the possible volume adjustments
are, in this order, LOW, HIGH, MUTE)
Call source selection (from main calling
station, from secondary calling station, to
fl oor, intercom, from switchboard)
Call tone selection
(1)
DS1160-008A