ION CAMOCAM Guida Rapida página 11

15 PODZ Latch
WARNING:
The latch must be locked in place to ensure the waterproof seal is activated –
failure to do so may cause water leakage.
8.2. Using the Wi-Fi PODZ
8.2.1 Installing and turning on the Wi-Fi PODZ
1. Remove your standard PODZ from the back of the camera
and place your Wi-Fi PODZ into the camera PODZ socket.
(follow steps 1 and 2 under section 3.4)
2. Press and hold the Power
camera.
3. Press the Wi-Fi power button on the Wi-Fi PODZ to turn on
your Wi-Fi. The blue LED lights up to indicate the Wi-Fi is
warming up. It will take approximately 15-20 seconds for the Wi-Fi to warm up and
become connectable. The LED will flash when the Wi-Fi function is active or
connected.
4. Press the Wi-Fi power button to turn off the Wi-Fi anytime.
Note:
Wi-Fi will drain your camera battery more rapidly when activated. Turn the Wi-Fi off if
you are not using it to change settings or upload content.
8.2.2 Connecting the Camera to a PC using Wi-Fi PODZ
1. Turn on your camera and Wi-Fi PODZ.
2. Go to the network settings of your PC and choose Wi-Fi settings. Search the network,
find and click "WIFIPODZ".
3. Enter password "123456789" and to connect to your camera.
4. Open your Internet browser and input "192.168.1.2". You will then be able to view the
files stored in your camera.
8.2.3 Connecting the Camera to Your Smart Device (Browser)
1. Turn on your camera and Wi-Fi PODZ.
Locks the PODZ
button to turn on your
EN-10