Electrical Connections; Control Panel; Lighting; Defrosting - Eurofred BFS 9 Instrucciones

3. Electrical connections

Your cooler operates on 230v/50hz.
The plug must be earthed. Use a 10a fuse. The socket must be out of reach of children. If the
plug does not fit to the socket, use an adaptor.
If you need to replace the plugged cord, use earthed plug.
The main electrical connections must be done by skilled electricians.

4. Control panel

The control panel is located at the top of the cooler. The control panel has a green lamp and a
light switch. The green lamp is on, when the cooler is plugged in. The light switch controls on/off
function of the fluorescent lamp.
The thermostat adjustment button controls the temperature in the cooler. Turn the button to the
right to increase the temperature and if turned to the left it stops. However, the cooler is still con-
nected and the green light is still on.
Temperature adjustment of wine cooler - see separate section.

5. Lighting

The models with canopy are equipped with interior light and the models with canopy are equip-
ped with interior light and canopy light.
To change the interior fluorescent lamp, remove the transparent protection plastic.

6. Defrosting

The evaporator defrosts automatically reducing the thermal conductivity. Defrosted water runs
to a container by means of a dropper in compressor area and evaporates.

7. Maintenance and cleaning

Switch the cooler off and take the plug out. Clean the interior of the cooler with a solution of one
tea spoon sodium bicarbonate to 0.5 litres warm water. Use a soft sponge. Do not use chemi-
cal cleaners. Dry the inside of the cooler after cleaning.
It is recommended that the condenser at the back of the cooler is cleaned by using a soft brush
or a vacuum cleaner at least every 6 months. The reject water system should also be cleaned.

8. Door reversal

As standard the door of the cooler opens to the right side (the door handle is on the left). The
door can be mounted to open to the left side. Instructions are as follows:
- remove the screws fixing the top hinge on the cabinet
- lift the door free of the bottom hinge.
- remove the bottom hinge.
- drill holes for the handle on the right side and move the handle from left to right.