Publicidad
Installation Instructions for AXBUCH-T2
Connections to be made
The AXBUCH-T2 can be connected two different ways
To retain the factory back-up camera to an aftermarket radio:
• Connect the Black wire to chassis ground.
• Connect the Yellow wire to accessory power. *
• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle.
• Disregard the loose Green/Purple wire, it will not be used in this application.
* It is highly recommended to use the AXCSD-6V (sold separately) to provide the camera
with the proper voltage.
To allow an aftermarket camera to be added to the OEM screen:
• Connect the Black wire to the ground wire of the aftermarket camera.
• Connect the power wire of the aftermarket camera to accessory power.
• Tape off and disregard the Yellow wire, it will not be used in this application.
• Connect the female Yellow RCA jack to the aftermarket camera.
The following (2) steps are only required if a
wire is not present in the factory harness.
•
If a wire is not present in pin-5 of the
5-pin connector of the factory radio,
unplug the connector, then insert the metal
pin of the loose Green/Purple wire into it.
Connect the harness back into the radio
• Connect the other end of the loose
Green/Purple wire to the reverse
wire of the vehicle.
®
Axxess Integrate
REV. 1/28/20
K
P
NOWLEDGE IS
OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
.
axxessinterfaces.com • metraonline.com
5 Pin Harness
1 2 3 4 5
This is the wire view of the
connector in the vehicle
Metra recommends MECP
certified technicians
Publicidad
