Gas Requirements; Leakage Test - MAURER ZANTE Manual De Instrucciones

•
Use butane, propane or LPG only.
•
The heater is designed for use with 11-13 kg (24-28 lbs.) cylinder. Maximum size of cylinder suitable for the
appliance, w/ regulator attached, is ∅31 cm x 64 cm (∅12" x 25"). Inner dimension of stand within the supporting
bars is ∅32 cm x 69 cm (∅12.6" x 27").
•
The appliance requires approved gas hose in 60 cm length and a regulator, or a gas hose in 140 cm length and a
regulator if no gas pipe (approx. 84 cm) is used.
•
Regulator maximum inlet pressure must not exceed 690 kPa (100 PSI).
•
Regulator outlet pressure to be 28 mbar (2.8 kPa or 11" W.C.) to 50 mbar depending to destination country.
•
The hose and regulator assembly must conform to local standard codes.
•
The installation must conform to local codes, or in the absence of local codes, to the standard for the storage and
handling of liquid petroleum gases.
•
A dented, rusted or damaged gas cylinder may be hazardous and should be checked by your gas supplier.
Never use a gas cylinder with a damaged valve connection.
•
The gas cylinder must be arranged to provide for vapor withdrawal from the operating cylinder.
•
Avoid twisting the flexible tubes and hoses.
•
Never connect an unregulated gas cylinder to the heater.
•
Disconnect the gas cylinder when the heater is not use.
Gas connections on the heater are leak tested at the factory prior to shipment. A complete gas tightness check must
be performed at the installation site due to possible mishandling in shipment or excessive pressure being applied to
the heater. The heater must be checked with a full cylinder.
5. Make sure the safety control valve is in the OFF position.
6. Make a soapy water solution of one part liquid detergent and one part water. The soapy water solution can be
applied with a spray bottle, brush or rag to all gas connections. Soap bubbles will appear in case of a leak.
7. Turn the gas supply ON.
8. In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply ON and recheck.
Contact your dealer or gas supplier for assistance if bubbles continue to appear.

GAS REQUIREMENTS

LEAKAGE TEST

WARNING
Never leak test while smoking.