camry Premium CR 1180 Manual De Uso página 4

device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact
professional electrician in this matter.
15. Avoid getting the device wet.
16. The device may only be wiped with a dry cloth. Do not use water or cleaning fluids.
17. The device should be kept in a dry room.
Device description
1.LCD Display
4.Preset
7.Navigate
10.Earphone socket
1. Before Starting
1.1 Network Requirement
Before using the CR 1180,the following requirements are needed:
● A broadband connection in combination with a wired/wireless access point, router or similar network device.
● The network device needs to support WIFI (802.11b/g/n) wireless connection.
● A PC or smart phone with a network ready. This network has to be the same one as the CR 1180 equipped with.
2. Getting stared
2.1 Get the network ready
. For wireless LAN(WLAN) network connection:
Check if WLAN LINK/ACT light of the wired/wireless access point or router is illuminated. Consult the user guide of that for any
questions.
Note: WiFi allows date transfer over short distances within up to 20 meters without the need of cabling between the devices, Any walls or
ceilings may reduce the strength of the WiFi connectivity.
Therefore try to locate the CR 1180 and/or the access point within the distance above, and avoid any obstacles between two devices.
. Connect the power adaptor to the back of the CR 1180 and plug into DC IN socket
. When it is first time running the device, the system will ask you to set Language and Network Configurations.
. Select Yes to establish connection to the network
. Select Yes(WPS)(Only for WPS routers).Then press the WPS button on your router.
If you answer 'Yes', the display goes to scanning for Wireless Network and shortly afterwards a list of available wireless networks will
appear.
The number of bars in the wireless symbol in front the network name(SSID) shows the relative signal strength of the network.
The key symbol indicates that the network is password-protected.
If the device does not find any wireless networks, No wireless Networks found appears on the display, Change your location, if necessary
and check your WLAN router.
SSID of your Access Point in the configuration of the Access Point(Router) .
Select your network and confirm with OK ,If your WLAN is password-protected, you will be prompted to enter your password.
Enter the password using the buttons on the device.
when entering the password.
You can rotate reel to choose the code. if it is accidentally pressed 'right' to move a redundant entry, Pressed 'left' to correct.
The cursor indicates the current entry space.
buttons:
'Left' Go to previous entry space, entry can be overwritten
'Right' Go to next entry space, the last entry is saved
'UP / DOWN' Select number/letter
'Enter' Confirm entire entry
It may take a few seconds to establish the connection to the network.
Once the connection is established, the main menu appears with the main
menu items:
- Internet Radio : Access to worldwide radio stations
- Media Centre: Access to your UPnP devices via software with streaming capability.
- Information Center: Access to weather, financial and system information
- Configuration : Various system settings
- Local Radio: Access to radio stations in a particular region (e.g. only German stations)
- My media U : Access to an online media library. This menu item only appears if the function has already been enabled under
Configuration
〉Manage my media U.
. Press and hold the Power I Menu button to enter standby mode. The time, date and any active Alarm times display on the screen.
. If you have setup a network connection, and use RFA021 again within the network, CR 1180 will automatically make the connection. In
case you desire to change the network, enter configuration to setup the corresponding connection.
2.Power I Menu 3.MUTE
5.Left 6.Right
8.Volume 9.DC IN
4
You can find the
Note the use of upper and lower case