Maintenance; Cord Tangling - Aqua Products EP37 Serie Manual Del Usuario

Maintenance

WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death,
disconnect (unplug) the cleaner from the power
source before performing any cleaning and
maintenance.

Cord Tangling

For optimal patterning and reduced tangling, the
floating cable should enter the water near the
middle of the pool length (Figure 14). Spread all of
the floating cable carefully in the pool, ensuring
there are no kinks or coils.
cleaner
WARNING: Do not use an extension cord.
Figure 14. Optimal Entry Point in Pool
IMPORTANT
Cleaner power cable may become tangled if
correct procedure is not followed after each
cleaning cycle.
If tangling occurs, follow these steps:
1. Gently pull the floating cable to bring
the cleaner within arm's reach. When
the cleaner is within arm's reach, use the
handle to remove from the water. Never
lift the cleaner out of the pool by the
floating cable (Figure 15).
Figure 15. Lift Cleaner From Pool with Handle
Control Unit
Figure 16. Hold Vertically to Drain Water
Recommended entry point.
Figure 17. Unplug the Floating Cable
2. Hold the cleaner vertically to drain (Figure
16).
3. Unplug power to the cleaner at the
control unit (Figure 17).
4. Remove the cleaner from the pool and
untangle all kinks and coils in the floating
cable. Start at the cleaner head. Lay the
cable in the sun to loosen any tangling
memory
(Figure 18).
11