Installation; Installation Requirements - Kenmore 580.74053 Manual Del Propietário

INSTALLATION REQUIREMENTS
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
22 to 36 inches (558mm to 914mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 14 inches (356mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
I I
FIG. 1
ELECTRICAL SERVICE
Check your available electrical service, The power
supply available must be the same as that shown
on the unit nameplate (found on left side of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding. Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary corrections. SAVE CARTON
and this OWNER'S MANUAL for future reference.
The carton is the best way to store unit during
winter or when not in use.
To avoid risk of personal injury, property damage, or
)roductdamage due tothe weightof this device and
sharp edges that may be exposed:
• Air conditionerscovered in this manual pose an
excessiveweight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques whenmoving unit.
• Carefully inspect location where air conditioner w ill
be installed. B e sureit willsupport t he weightof
the unitover an extendedpedodoftime.
• Handleair conditioner w ithcare. Wear protective
gloveswheneverliftingor carrying the unit.AVOID
the sharpmetalfinsof front and rearcoils.
• Make sureair conditioner d oesnot fall during
installation.
INSTALLATION HARDWARE
ITEM NAME OF PARTS Q'TY
A SHORT SCREW 11
B WOOD SCREW 5
C L BRACKET 3
D FOAM STRIP 1
E FOAM SEAL 1
F SIDE CURTAIN 2
G DRAIN PIPE 1
H SUPPORT BRACKET 1
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end
wrench or adjustable
wrench
* 1/4-inch hex socket
and ratcher
•Tape measure
• Electdc drill
• 1/4-inch drill bit
-5-