Sebson GS546 Manual De Instalación página 14

Information about the battery:
This smoke detector contains a non-replaceable lithium battery. Under normal conditions the battery has a lifetime
of approx. 10 years. When the battery is running low, a short warning tone sounds every 40 seconds for about 30
days and the LED flashes briefly. During this time the smoke alarm is still fully functional. However, it is strongly
recommended to replace the device immediately! After approx. 30 days the device is no longer functional and
switches off. Replace the device after an operating period of 10 years!
Note: The recurring warning sound can be muted for about 10 hours by pressing the TEST button. After 10 hours, a
short warning tone sounds again every 40 seconds.
General instructions for using batteries:
Danger:
Never expose batteries to extreme conditions, such as heat or strong sunlight! There is an acute risk of
explosion and leakage!
Danger:
Make sure that batteries can not be swallowed by children, animals and adults! In particular, keep children
and animals away from this product! If one or more batteries are swallowed, seek medical attention immediately!
Here is an acute danger to life. The substances contained in the battery can cause severe poisoning!
Caution:
Remove leaking batteries from the device immediately! The battery acid contained in the battery can
damage the unit! Avoid direct skin contact with leaking batteries! Wash your hands immediately after contact and
take care that the battery acid does not get into your skin, eyes or mucous membranes! Dispose of leaking and old
batteries according to the regulations.
 Replace old batteries with batteries of the same type!
 Do not use rechargeable batteries. They have a too low voltage!
 Remove the batteries from the battery compartment when you are not using the remote control for more than
a month. Make sure that the battery compartment is always closed when the battery is inserted!
 Only operate the device when the battery compartment is closed!
Non-rechargeable batteries are not to be re-charged!

 New batteries should not be used together with used batteries!
 Always use batteries with the same type!
 Never short the terminals of the batteries!
Start up:
Note:
The alarm tone that sounds during the function check is quieter to protect your hearing than the actual alarm
tone in case of fire.
Attention:
Check the function of the smoke detector weekly!
Activation of the smoke detector (see Fig.7):
Attach the mounting ring to the back of the unit until it is fully engaged. Note: This requires a little more force. It is
recommended to fix the mounting ring to the ceiling with a screw beforehand.Then press and hold the TEST button
for about 3 seconds until the LED lights up and a short beep is heard. The smoke detector is now ready for
operation.
Functional check:
To check the function, keep the TEST button pressed for approx. 5s. The alarm tone sounds and the LED lights up
red. This is to check whether the electronics, the smoke detector's alarm unit and the battery are functioning. The
alarm tone stops immediately after releasing the TEST button.
Note: If neither the alarm sounds nor the LED flashes, the battery is may be empty or the device may be defective.
Replace it with a new functional device!
14