Completing Installation; Programming With The Easy Controller - Gewiss CHORUS GW 10 767 Manual Del Usuario

3.5
Insert the devices into a Chorus support, making sure the two local
command buttons are on the left. Complete the installation with
other Chorus devices or hole covers and fix it to the relative container
(flush-mounted box, wall-mounted box etc). Apply the finish plate.

PROGRAMMING WITH THE EASY CONTROLLER

4.
Programming the actuator through the Easy base unit (code GW 90 831) or
with Easy Controller (GW90837 / GW90838 / GW90840).
The device can be selected by proceeding as follows:
• by pressing one of local command buttons: the corresponding channel
will be highlighted in the channel list;
• directly from the list of channels.
The functions can be created after the device has been selected.
Refer to the Easy base unit or Easy Controller documentation for further
information on the programming procedures.
Names of the functions
blinds pushbutton
blinds
Shutter edges
scene
priority control
Wind sensor
Rain senso

COMPLETING INSTALLATION

Handling of shutters or blinds using blinds
pushbutton
Handling of shutters or blinds using blinds
Handling command for shutters or blinds
with edges
Actuation and memorising of the scenes
Override actuation
Actuation with wind alarm
Actuation with rain alarm
21