Replacing The Connecting Cable; Converting The Headphones Into A Headset - Sennheiser HD 280-13 Instrucciones Para El Uso

HD 280 BDA 6.6.02

Replacing the connecting cable

Replace the connecting cable if it is damaged. To do so,
please proceed as follows:
Remove the ear cushion. Grasp behind the ear cushion
and pull it up and away from the earcup.
Loosen the screw
Remove the cover from the earcup
Pull the connector
Remove the antikink protection of the connecting cable
from the holding device
Insert the antikink protection of the new connecting
cable into the holding device.
Plug the connector
the socket as shown in the diagram on the left.
Put the cover back onto the earcup
Replace the screw
Slide the ear cushion onto the earcup.

Converting the headphones into a headset

If you wish to convert your headphones into a headset,
please contact your Sennheiser service partner who will
equip the headphones with a microphone.
17
and remove it.
.
out of the socket.
.
of the new connecting cable into
.
and tighten it.
06.06.2002, 9:49 Uhr
17