Connections To Be Made; Important Warning - Axxess AX-ADBOX Serie Instrucciones De Instalación

Installation instructions for AX-ADBOX2

Connections to be made

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the (2) Red wires to the ignition/accessory wire.
• Connect the Orange/White wire to the illumination wire. If the aftermarket radio does not have
an illumination wire, tape off the Orange/White wire.
• Connect the Blue/White wire to the amp turn on wire (this wire must be connected to hear sound
from the factory amplifier).
• Connect the Brown wire to the mute wire. If the aftermarket radio does not have a Mute wire,
tape up the Brown wire.
For aftermarket radios with navigation built-in
• Connect the Light Green wire to the parking brake wire
• Connect the Blue/Pink wire to the V.S.S. or speed sense wire
• Connect the Green/Purple wire to the reverse wire.
Note: For the remaining wires, please refer to the instructions supplied with the required
wiring harness.
METRA. The World's best kits. 1-800-221-0932
™

IMPORTANT WARNING

This product includes instructions for installation
which must be carefully followed. The instructions are
worded in such a manner to assume that the installer is
capable of completing these type of electronic installations.
If you are unclear as to what you are instructed to do or
believe that you do not understand the instructions so as to
properly and safely complete the installation you
should consult a technician who does have this
knowledge and understanding.
Failure to follow these instructions carefully and
to install the interface as described could cause harm
to the vehicle or to safety systems on the vehicle.
Interference with certain safety systems could cause
harm to persons as well. If you have any questions in
this regard please call the Help line or Metra at
1-800-221-0932 for assistance.
metraonline.com
© COPYRIGHT 2004-2014 METRA ELECTRONICS CORPORATION
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians