Amana XRSS287BB El Manual Del Propietario página 21

ICE & WATER
UPQD8Ã
Ice maker is not producing
ice (some models-continued)
Unit is leaking water
Ice forms in inlet tube to ice
maker
Water flow is slower than
normal
Dispenser water is not cold
Ã
QPTTD7G@Ã86VT@Ã
Improper water valve was installed.
Plastic tubing was used to complete water
connection.
Improper water valve was installed.
Water pressure is low.
Freezer temperature is too high.
Water pressure is low.
Improper water valve was installed.
Water inlet tubing has kinks.
Water filter is clogged or needs to be
changed.
Refrigerator has been recently installed
Water supply in holding tank has been
depleted.
Water has settle into water lines outside
holding tank and has warmed to room
temperature.
Before Calling Service
Ã
TPGVUDPIÃ
Check water connection procedure in your Installation
Instructions . Self-piercing and
water pressure and may clog the line over time. Amana is not
responsible for property damage due to improper
installation or water connection.
Amana recommends using copper tubing for installation.
Plastic is less durable and can cause leakage. Amana is
not responsible for property damage due to improper
installation or water connection.
Check water connection procedure in your Installation
Instructions. Self-piercing and
water pressure and may clog the line over time. Amana is
not responsible for property damage due to improper
installation or water connection.
Water pressure must be between 20 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inch is recommended for units with
water filters.
See the controls section in your Owner's Manual for
assistance on how to adjust your controls. Freezer is
recommended to be between 0 to 2°F (-18 to –17°C).
Water pressure must be between 20 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inch is recommended for units with
water filters.
Check water connection procedure in your Installation
Instructions . Self-piercing and
water pressure and and may clog the line over time.
Amana is not responsible for property damage due to
improper installation or water connection.
Turn off water supply and remove kinks. If kinks cannot be
removed, replace tubing.
Change water filter.
Allow approximately 12 hours for water in holding tank to
chill.
Discard first glass of water and refill.
21
3
/ " saddle valves cause low
16
3
/ " saddle valves cause low
16
3
/ " saddle valves cause low
16