Metrolight SmartHID Guía De Inicio Rápida página 3

The installation should only be undertaken by a qualified electrician in accordance
IMPORTANT
with the National Electrical Code and applicable local codes and ordinances.
COMMUNICATION
Analog dimming
0-10V
Violet
Gray
Black
White
0
Green
COMMUNICATION
Analog dimming
0-10V
Violet
Gray
Brown
0
Blue
Green/Yellow
* NOTE: There are two types of ballast ranges: A. Standard range of up to 10m/32ft; B. Non-standard range for longer cables
Always isolate
unused
exposed wires
WARNING:
Failure to install the Smart Electronic Ballast properly could void the product's warranty.
All components on the output line must be at least 4KV Pulse Rated.
Lamp wires and connections must be well isolated from chassis (EARTH/GROUND)
Verify that wires' insulation is not damaged (without cuts).
Damaged wires are dangerous and might cause harm to people and/or equipment.
Time limitation of the ignition voltage on the SmartHID™ is less than 30 minutes
(MADLI)
(MADLI)
DO NOT Connect the input to the output
For the SmartHID™ 175W-600W Electronic Ballast/Driver
If the distance between the lamp and the Ballast is more than 2m,
DO NOT connect EARTH/GROUND wire of the output cable.
Use an additional GROUND wire to ground the fixture.
Extension Cable
Blue
OR
16AWG-20AWG
Red
HIGH
Voltage
50Ft.*
MAX
OR
White
16AWG-20AWG
Red
HIGH
Voltage
15meters*
MAX