Cleaning Filters; Parts & Supplies - Bissell POWERGLIDE LIFT-OFF PET PLUS 2043 Serie Guía Del Usario

Cleaning Inner Cyclone

Cleaning Filters

WARNING
Do not operate vacuum with damp or wet filters, as well as without filters or the Dirt
Container in place. Allow components to dry before reassembling the Dirt Container.
1
3
NOTE: The post-motor filter is a pleated filter. This filter is not washable and must
be replaced when it becomes dirty.
Parts & Supplies
For Parts and Supplies, go to www.BISSELL.com and enter
your model number in the search field.
8
www.BISSELL.com
With dirt container off vacuum base, push the empty tank
1
button and twist counter-clockwise to remove the separator
and pull down.
Tap separator against inside of trash bin and rinse with warm
2
water if necessary. Be sure to let it completely dry before
placing back in the dirt container.
Place separator back in, being sure to align each tab on either
3
side of the top of separator with the notches inside the top of
the dirt container.
With vacuum
unplugged,
remove the tank
and lift up on the
tab attached to
the filter cover.
Remove post-motor
filter located on the
front of the vacuum
underneath the filter
cover. If it appears
dirty, remove the filter
and gently tap the
filter on the edge of a
waste basket.
2
4
There are 2 filters
here; one foam
filter on top and
a thinner fiber
filter; both are
washable.
Replace the post-
motor filter by
pushing it straight
back, clicking
each side.