Descargar Imprimir esta página

DURABLE 5085 Manual Del Usuario página 26

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
EN
English
Securing the monitor arm to the table column
▶ see figure 6
– Engage the arm bracket (4) into the table pillar (5) from above.
To do this, guide the slot nut (11) on the arm bracket into the
groove on the table pillar.
– Fix the arm bracket (4) at the required height using the adjust-
ing screw (12).
Securing the monitor brackets
▶ see figure 7
– Push each monitor bracket (2), right and left, over the monitor
arm (3).
– Secure the monitor in position using the adjusting screw (13).
Note:
Make sure that the monitor brackets are attached to the
monitor arm so that the adjusting screws are at the bot-
tom.
▶ see figure 8
– Push the cap (17) onto the table pillar and the end caps (18) onto
the monitor arm.
Monitor mount
▶ see figure 9
– Lay the monitor on a flat surface with the display facing down-
wards. Place a blanket or similar under it for protection.
– Remove any coverings in the mount area of the VESA plate (1)
on the monitor. Consult the monitor manufacturer's operating
instructions.
– Fasten the VESA plate  (1) to the monitor with the enclosed
screws  (19). Make sure that the plate is properly located. The
clamps must point towards the upper edge of the monitor.
– Insert the enclosed covering cap (20).
26

Publicidad

loading

Este manual también es adecuado para:

5086