MAC TOOLS UC3016-1DRW-BK Manual De Operación página 4

ASSEMBLY INSTRUCTIONS
Step 4 Tools Needed: Phillips® #3 Screwdriver & 10mm Combo Wrench
Flip Cart Over. Place washer (#4) onto round head bolt (#3).
Insert bolt assembly into aligned bolt holes of bottom shelf (#7)
and legs (#2) of front right. Place washer (#4), then split lock
washer (#5) and then hex nut (#6) onto bolt assembly and tighten
but do not torque.
Repeat entire process for rear right.
Step 5 Tools Needed: Phillips® #3 Screwdriver & 10mm Combo Wrench
Place the cart upside down. Torque all eight bolt assemblies
(#3, #4, #5, #6) to 5 ft lbs.
Locking Swivel Caster (#8)
Non-locking Swivel Caster (#9)
Step 7 ATTACHING HINGED LID
Tools Needed: Phillips® #3 Screwdriver & 10mm Combo Wrench
Position the cart right side up and open the lid. Insert the round
head bolt (#11) from the inside of the cart hinge bracket. Place a
washer (#12) onto the bolt and then insert into the hinge (#10).
Make sure the hinge bends inwards towards the lid hinge.
Tighten bolts - do not torque.
Step 8 Tools Needed: Phillips® #3 Screwdriver & 10mm Combo Wrench
Insert the round head bolt (#11) from the outside of the hinge (#10).
Place a washer (#12) onto the bolt and then insert into the hinge
back of the lid. Torque both bolt assemblies to 5ft-lbs.
UC3016-1DRW-RD/ UC3016-1DRW-BK/ UC3016-1DRW-BL/ UC3016-1DRW-LG/ UC3016-1DRW-OR
UC3016-1DRW-BK/UC3016-1DRW-BL
UC3016-1DRW-LG/UC3016-1DRW-OR
6
UTILITY CART WITH LOCKING LID
4 & 5
Bottom Shelf
(#7)
Step 6 ATTACHING CASTERS
Insert the casters (#8) & (#9) into the hole in the white plastic
inserts until the caster is flush with the white plastic insert.
Using a rubber mallet, hammer the casters in place until the
stem is no longer visible. Repeat with the other three casters.
NOTE: Make sure the two casters with locks (#8) are on the same
side of the cart.
7 & 8
Hinge
Bracket
(#10)
#12
#11
4
UC3016-1DRW-RD
Round Head Bolts (#3)
Washer (#4)
Split Lock Washer (#5)
Hex Nut (#6)
Chrome
Legs (#2)
Locking
Top
Assy. (#1)
07/22/2020