Clean Ing Agitator - Kenmore 116.31195 Manual De Uso

CLEAN ING AGITATOR
WARNING
Always unplug power cord from
electrical outlet before performing
any servlce on vacuum cleaner.
1. Clean agitator
after every five
uses and every
time the belt is
replaced.
2. Remove lower
plate. (See
REPLACING BELT,
p. 20-21).
3. Cut off any hair, _
thread, string,
carpet pile, and lint
entangled around
agitator with a pair
of scissors.
4. Remove agitator. (See REPLACING
BELT,p. 20-21)
5. Remove any string or debris located
on the end caps, washers or agitator
shaft.
6. Reinstall agitator and lower plate. (See
REPLACING BELT, p. 20-21)
REMOVING CLOGS
CLOGS IN BODY AIR PATH
if the vacuum cleaner does not seem to
have adequate suction, first check if the
dust cup is full or if a filter is clogged.
1. Turn off and unplug the vacuum
cleaner.
2. Remove dust cup and check for clogs.
3. Check the hose inlet area.
4. Visually inspect the tools, the hose, and
the nozzle hose area into which the hose
is connected.
5. Check the suction inlet area.
6. Remove any visible clog.
7. Reinstall dust cup and plug in the
vacuum cleaner and turn it on.
Suction
Nozzle
Hose Inlet
=22 =