Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of the Refill Bottle and Pump
1. Return the refill bottle to the dispenser. The refill bottle
markings should face outward to be lined up correctly.
2. Gently slide the refill bottle and pump head into the
dispenser, it will sit on top of the battery compartment.
The pump will fit within the battery compartment grooves.
Make sure the push rod engages in the empty position
1 on top of the discharge nozzle of the pump
(see figure 7).
3. You can select a single or double dispensing cycle.
To select single or double dispensing cycle you press
the black pumping cycle button (see figure 7).
Tip: A double dispensing may be preferred with a
thick gel or foam soap.
Light will flash 3 times for single cycle dispensing.
Light will flash twice rapidly 3 times for double cycle
dispensing.
4. Close and lock dispenser cover.
Product Usage
1. The indicator light on the front of the dispenser
will be green when it's ready to use.
2. Place hands under the dispenser to activate
the infrared sensor.
3. The light turns red when the batteries are low
or the sensor is still activated by a hand or object,
even though the cycle is complete.
E-6
7
Black
Pumping
Cycle
Button
Push Rod
Indicator Light
TROUBLE SHOOTING GUIDE
SOLUTION
PROBLEM
Unit won't power on.
Make sure batteries are inserted properly.
Replace with new batteries.
Too much/too little soap
Adjust the liquid volume (see filling instructions).
is being dispensed.
Make sure batteries are working properly.
No liquid is being
dispensed.
Confirm dispenser is connected and in the liquid.
Refill soap.
Remove any soap build up from pump.
Unit turns off.
Make sure batteries are working properly.
Batteries are low.
Indicator light is Red.
The unit sensor is still activated by a hand or object, even
though the cycle is complete. Remove hand/object.
E-7
Publicidad
Tabla de contenido
