Transport And Storage; Assembly; Required Tools - Bosch Rexroth LTU350/1 Manual Del Usuario

24/84 Bosch Rexroth AG
5

Transport and storage

For storing and transporting the product,
always observe the ambient conditions
specified in the technical data (see
"Technical data" on page 27).
6

Assembly

When installing the product, always observe
the ambient conditions specified in the
technical data (see "Technical data" on
page 27).

Required tools

• Screwdriver (size 0.8 x 4.5 mm)
Assembling LTU350/1 servo
amplifier
CAUTION
Risk of damage to persons
and property!
Assembly of the LTU350/1 servo
amplifier requires basic mechani-
cal and electrical knowledge.
yOnly qualified personnel (see
"Personnel qualifications" on
page 18) are authorized to as-
semble the LTU350/1 servo
amplifier.
yMeasures to prevent electro-
static discharge (ESD protec-
tion) must be undertaken to
protect the module and system
components during all assem-
bly work.
LTU350/1 | 3 609 929 B47/2008-12
CAUTION
Risk of injuries when
assembling under voltage!
If you do not switch off the power
supply before assembling the
LTU350/1 servo amplifier you
may become injured or the device
or system components may be
damaged.
yAlways switch off the power
supply to the relevant system
component before assembling
the LTU350/1 servo amplifier.
1. Switch off the power supply for the
BT356 card rack or SB35x system box
and allow for a discharging time of
10 seconds.
2. Completely insert the LTU350/1 servo
amplifier into the respective slot in the
BT356 card rack or SB35x system box.
3. Tighten the knurled bolts on the front.
Make sure that the front panel is flush to
the BT356 card rack or SB35x system
box by tightening the knurled bolts.