Blade Assembly; Light Kit Assembly. Pgs - Litex Industries WC42BNK5C1 Guia De Instalacion

8. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat this procedure with remaining blade
arms. Secure all screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Remove 3 screws from top of light kit fitter.
Remove finial, finial plate, and rubber washer
from bottom of light kit fitter. Save finial, finial
plate, and rubber washer for later use.
Locate BLUE and WHITE wires in switch
housing labeled "FOR LIGHT KIT CONNECTION".
Remove and discard plastic that holds these 2
wires together.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLUE
(or BLACK) wire from switch housing to BLACK
wire from light kit fitter. Make sure that molex
connections are secure.
["Light Kit Assembly" continued on next
page.]
plastic
motor
lock
lock washers
motor housing
switch
housing
light kit fitter
rubber washer
finial plate
page 6
motor
housing
blade attachment
screws and washers
J
blade
blade arm
blade arm screws
molex connections
switch housing
cap
finial