Litex Industries WC42BNK5C1 Guia De Instalacion página 8

9. Light Kit Assembly. (cont.)
To attach light kit fitter to motor assembly,
align holes in switch housing cap with holes in
switch housing. (Note: Make sure to align gap
on top edge of the switch housing cap with
the reverse switch on switch housing for the
correct fit.) Re-insert 3 screws that were
previously removed and use a Phillips
screwdriver to secure all screws.
Install 2 candelabra base 60 watt max. bulbs
(sold separately).
Important: When you need to replace bulbs,
please allow bulbs and glass shade to cool
down before touching them.
Locate rubber washer, finial plate, and finial
that were removed on the previous page.
Place rubber washer inside glass shade over
center hole. Raise glass shade in order to guide
pull chains through corresponding holes in
glass shade. Align hole in center of glass shade
with threaded rod on light kit fitter and push
up gently until threaded rod comes through
hole. (Be sure pull chain for fan operation does
not rub against bulb during operation.)
Align hole in center of finial plate with
threaded rod, allowing the pull chains to come
through appropriate holes in finial plate, and
push up. Thread center pull chain through hole
in finial. Screw finial onto threaded rod to
secure glass shade to light kit fitter.
Note: Do NOT overtighten finial as glass may
crack or break.
motor housing
reverse
switch
motor housing
glass shade
page 7
switch
housing
bulb
light
kit fitter
light kit fitter
rubber
washer
threaded rod
finial plate
finial