Vortice VortDispenser PRO Manual De Instrucciones página 18

ENGLISH
5. Align the holes on the dispenser fixing plate with the M4x16 mm screws and carefully place the
dispenser on the screws (1).
Open the front cover of the dispenser with the key provided and pressing the two brackets located
next to the nozzle, remove the tank completely from the unit. Secure the dispenser to the back
plate by tightening the pre-attached screws and the third screw (2) with the wrench provided.
Reinstall the nozzle and tank in the dispenser (3).
Please note that there is a wall mounting kit supplied with the dispenser itself. It is not
necessary to use it in this case..
M4x16 mm screws
Holes for fixing
1
VortDispenser PRO
6. Fill the tank with your disinfectant or soap of choice by either removing the tank completely from
the unit, pressing the two latches situated by the nozzle and pulling the tank, or simply leaving it
inside the dispenser and opening the top lid.
18
2
Key
M4x16 mm
screws
3 mm
3