Before Use - UFESA MF4090 Manual De Instrucciones

EN
maintenance.
The water should be replaced every 3-4 days, even if it has not been used. In case the appliance has
not been used for long periods, remove the water from the humidifier
B&B TRENDS, S.L. will not be held liable for any harm or damage which may occur to people, animals
or objects as a result of failure to observe the aforementioned warnings.
USE

Before use

Make sure all the packaging has been removed from the appliance.
Assembling the mist fan
ASSEMBLE THE BASE
Insert the 5pcs wheels (20) into the weight rubber (19),and tighten up by the screws (21) and the gasket
(22).
ASSEMBLE OF BLADE AND GRILLE (FIG. 1)
Unscrew the plastic mounting nut from the front of the motor housing by rotating it anticlockwise.
Position the rear grille against the front of the motor housing with the handle uppermost, ensuing that the
locating pegs on the motor housing are engaged correctly in the holes of the rear grille.
Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN IT.
Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin that
passes through the motor shaft.
Tighten the blade cap by turning it anticlockwise.
ASSEMBLE OF THE SUPPORT TUBE
Fix the decoration ring (1) on the front grill (2), and tight up by misting board lock screws.
Position the front grill (2) and back grill (5) by grill ring (6), and tighten up by grill lock nut.
Untighten the nuts (10), place the 2 support tubes into the base and tight again the nuts (10).
The support tubes (23) have to be placed into the base (18) and tighten by screwing.
ASSEMBLE OF THE WATER TANK
Make sure the product is unplugged from the mains before filling or refilling the water tank.
Only put water in the water tank. Do not add any chemicals, oils or other additives.
Only use cold or lukewarm water in the water tank. The water must not be warmer than 40°C.
Unscrew the valve cover to open the tank turning it anticlockwise, fill the tank with cold and clean
water making sure not to overfill it. To close the tank, screw the valve cover back on securely turning it
clockwise (fig.2).
Turn the tank over and place it back into its designated space at the back of the fan main body (fig. 3).
Insert the plug into the mains socket.
Remote Control
Supplied with batteries inside; Remote control is supplied with battery inside; remove the transparent
sheet from the battery cover before use remote control.
When the battery is over, it must be replaced with the same type following the drawing on the back of
remote control.
Operation
Press On/Off button (A) one time to activate the fan. The indicator light (6) will light on.
You can now press MIST (F) button to select the misting function without fan operation (mist only).
Press On/Off button a second time to turn on the fan: the unit will operate at low speed and normal
16