How Do I Turn On The Finder - PAJ GPS Finder 2.0 Manual De Instrucciones

1. Connect the PAJ GPS FINDER to the cable harness using the
black plug-in port.
2. Connect the device to the battery. Connect
with the fuse to (+).
Please note: The poles must never be reversed.
Note: When connected to the power supply, the PAJ GPS
FINDER immediately turnes on, and the LEDs start blinking.
If the FINDER is not connected to the vehicle battery, but at a
different point (e.g. fuse box), this can result in the ignition
on / off function not being accurately recognized.

1.6 How do I turn on the FINDER?

The PAJ GPS FINDER automatically turns on when connected to
an external power supply. This is usually the battery of your
vehicle.
We recommend that you park the vehicle outside when you
first connect the FINDER. After a few minutes, the GPS
FINDER should have set up a valid GPS signal. You can now
see the location on the map and continue to use the vehicle
Connect the black cable to minus (-).
Black
1.
Red
Fuse
as usual.
Vehicle Finder 2.0 4G by PAJ GPS V.1.0 US
© PAJ GPS Inc.
2.
Battery
2.
8-32V
7
the red cable